Новости

R3 DC/DC converter for FTU Application

Abstract 

    In the electrical power industry, equipment such as RTU*, DTU*, FTU* and TTU* are switch monitoring devices installed in the substation close to the feed breakers (a disconnector which is located in series at the end of a feeder, within a substation bay, in order to isolate the system), which is widely suitable for use in automation engineering applications, urban, rural or enterprise power distribution networks. These can be used for automated functions such as monitoring, protection, and communications in a ring network cabinet in the distribution substation and master station with the implementation of monitoring and fault identification, isolation, and power recovery of the fault in the distribution network. The internal structure and design are very similar to power supplies. 

    [1] RTU:Remote terminal unit 

    [2] FTU:Feeder terminal unit 

    [3] TTU:Distribution Transformer supervisory Terminal Unit 

    [4] DTU:Data Transfer unit Typical FTU* system structure

    The chart above shows that FTU monitors three-phase current, voltage, and binary signals by way of data analysis. 


The power supply requirement is as follows: 

● Employing a UPS (uninterruptable power supply) by inserting a dual power supply for switched power and automatic battery switching. 

● DC-DC converter with the ability to work within a wide input voltage range caused by the charge and discharge from battery banks. 

● DC-DC converter must be compatible with both 24V and 48V battery voltage input. 

● High 3KV isolation voltage of the power supply can isolate the interference away from the AC end of the primary power source. 

● System power break time remains more than 500 ms when the power supply and the battery power supply disconnect. 


Recommended Power supply solutions 

To satisfy the above requirement for a power supply, Mornsun has recently released its URF_LP-20WR3 series which is a 20W 3000VAC high isolation range of DC/DC converters


Featuring 

● High efficiency 

● Wide Operating temperature between -40℃ to 85. 

● Wide 4:1 (18-75V) input which suits both 24V and 48V battery input voltages. 

● Isolation voltage up to 3000VAC can isolate interference introduced from the battery charging side. 

● Design meets EMC - CISPR22 / EN55022 CLASS A 


Recommended product 

● URF2405LP – 20WR3 


Design reference 

● Power-off-delay: The extension of power-off time is necessary for the system to save data during a power outage of the main power supply and battery. The most common method to do this is to add some high-value capacitors (could be as high as several thousand μF). Capacitors with a higher capacitance will be needed for the input, especially in situations where the input voltage drops away, so the power of time delay will also be greatly reduced. 

● For a higher level of EMC requirement, please kindly refer to the datasheet.

0

Return
Return
Prompt
Пожалуйста, заполните поля правильно.

Проверка прошла успешно

This website uses cookies able to make your time on our site a lot less crummy and a much richer experience. For more information, please visit our Privacy Policy.

close
Privacy Policy

Контакты

close
MORNSUN distributors for part ""
Distributor Stock Qty  
NAC Group, Inc. 0 Buy online
Edge Electronics 0 Buy online
DigiKey Electronics - Buy online

Find the right contact in your region

Local distributorsContact us
close
  • File Name